Drop it on your drop bar

Our Roadie Bar Lever Kit is designed to mount in the drops of your road drop style handlebars, turning your Cyclocross or Gravel bike into the ultimate rig. Whether getting the saddle out of your way during descents in your local CX race series or providing a little needed relief during a long gravel road ride, we now have the answer for you.

Lifetime Warranty

We've always got
your back

Fast Shipping Options

Get your parts for the
weekend ride

Unparalleled Service

Seriously, we're here
for you

Pacific NW Approved

All Season reliability, tested in the mountains

How Does Travel Adjust work?

Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:

  1. Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
  2. Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
  3. You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
  4. Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
  5. After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.

How Does Travel Adjust work?

Our travel adjust system allows for a total of 30mm travel reduction in 5mm increments. If you were riding that line between travel sizes you can now fine-tune the perfect fit by following the easy directions below:

  1. Begin by lowering your dropper at or below the desired travel length (just make sure it’s not fully extended!)
  2. Unthread the midcap with your hand and slide it up to reveal the white DU Bushing.
  3. You’ll see negative numbers with corresponding notches machined into the post (each # represents decreasing travel.
  4. Slide the DU bushing up and rotate it to align the black arrow with the amount of travel you would like to reduce, then seat the arrow into the machined groove. (Make sure it’s fit securely into these notches!)
  5. After pushing the DU Bushing back down, lower the midcap and hand tighten (no need to go overboard!) and ride off into the sunset with the perfect travel for you.

Specs: Drop Bar LEver kit

compatibility

Works with cable actuated droppers

clamp

Designed for 24mm diameter road bars

kit includes

Cable and housing

Manuals

levers

drop bar lever kit

Warranty

PNW Lifetime Warranty

Do we have your back? Of course. If anything goes wrong, we're here to do everything we can to ensure you're taken care of.